Japan TELEC Certification

The radio law requires that the specified radio equipment be approved (ie, the technical regulations compliance certification). TELEC certification is mandatory, the certification body for the MIC in the designated radio equipment approved certification body. TELEC (Telecom Engineering Center) is a major registered certification body for Japanese radio equipment compliance certification.

(2) TELEC certification standards

TELEC-certified technical standards refer to the classification and technical standards for the specified radio equipment listed in the official online technical regulations compliance certification system. It is noteworthy that these technical standards and radio regulations (Radio Regulatory Commission Rules No. 18) technical requirements are different, the "radio regulations" shall prevail.

(3) TELEC certification type

TELEC certification includes Test Certification and Type Certification. The test certification is validated for each device unit, which is valid only for each validated device unit;

Type certification means that the same design and manufacture of a batch of equipment to verify the sample, the certification of the batch of equipment are effective, but if the equipment design or manufacturing has changed, the device will need to re-certification.

It is worth noting that the use of non-low-power radio stations and their terminal equipment requires a license to MIC.

In addition, for the telecommunications terminal equipment compliance certification in two cases:

a.For ordinary telephone devices, as long as the telecommunications business law required JATE certification;

b.For wireless terminal equipment, in addition to the need for telecommunications business law required for JATE certification, but also need to be required by the radio law TELEC certification.

(4) TELEC certification mark

(5) wireless communication equipment TELEC certification's information

a.Technical Type Specification Form;

b.Declaration of Quality Management System;

c.Letter of Quality Control Confirmation MethodorManufacturer’s ISO 9001 Certificate;

d.Letter of Construction Protection Confirmation;

e.Rated Power Declaration;

f.Antenna Report;

g.Test Reports (including Test Results, Test Setup Photos and Examinations carried out);

h.Block Diagram, Schematic Diagram, Bill of Material, Parts Placement, IC Data Sheets, Internal and External Photos, Product Description, User manual, Operational/Technical Description, Description of Pheripherals/Accessories;

i.Label Information(Label Location, Label content);

If you act as agentoras authorized representative of the manufacturer.

j.Power of Attorney / Authorization Letter;

Note: All submitted documents are recommended for Japanese documents, English documents can also be accepted. Test reports can be made using the language used by local testing organizations.

(6) TELEC certification to WLAN and bluetooth products

TELEC is Japan's mandatory certification for wireless products, some similar to the domestic SRRC. It follows the Japanese radio wave method. The specific test specification is to follow the MIC (Japan Ministry of Internal Affairs and Communications) Notice No.88 regulations, see the following link:

Http://www.tele.soumu.go.jp/j/material/test.htm

The update maintenance of the test specification is also carried out by the MIC.

WiFi and Bluetooth products, the test project is basically similar to the European standard EN300 328.

The standard for 2.4GHz WiFi products (802.11b / g, 2412-2472 MHz) and Bluetooth products is MIC Notice No.88 Annex43, but for 14 channels (Channel 14: 2471 - 2497MHz) for 2.4GHz WiFi products, Using Annex44 for testing and reporting, the corresponding fees also need to increase.